|
Functions, characteristics
The HX-101 heat exchanger unit is a high efficiency heat exchanger unit
employing Lintecfs liquid vaporizer unit construction. In order to vaporize
liquids it is necessary to apply heat efficiently to the liquids. An efficient
vaporization unit can be used without major modification as an efficient
heat exchange unit. Because the HX-101 employs this vaporization unit construction,
high efficiency and compactness have been realized. In addition, due to the use of a clean
construction employing 316L stainless steel for gas contact surfaces, this
device can be used not only for exhaust lines but also process chamber inlets,
as well as the heating of a wide range of process and vaporization unit carrier
gases. As a safety mechanism a thermal switch
is built in as standard and this can be used as an alarm signal in case of
overheating. Please use this device for the heating of all kinds of gases. The HX-101 heat exchanger unit is divided into two types, the HX-101-L100
and the HX-101-L300, depending on the capacity of the heaters used. The
L100 can heat gas flow rates of up to approximately 100 litres per minute,
while the L300 is capable of heating gas flow rates of up to 300 litres
per minute. For smaller flow rate applications Lintec has available the HX-10A which
is capable of heating gas flow rates of up to 50 litres per minute. In addition, we also have available control units including temperature
control and flow rate control units as well as alarm functions. |
